Oil level control parameters for the oil station in the polymerization reactor
Thread Content
Question: What level should the oil level in the agitator tank’s oil station be to be considered normal? Thank you!
Discontent is sufficient; note that a rapid drop in liquid level indicates a leak in the machine seal, so it is necessary to continuously monitor the liquid level in the oil tank and top up the oil before repairing the mixer seal after discharge. An increase in liquid level suggests that cooling water has entered the oil, and the oil should be replaced and the system repaired after the reaction is complete and discharge takes place
Not less than one-third of the oil level, and not more than two-thirds of the oil level. It’s easier to observe this way.
The tank must be filled to the top at the first gas station. Add it a second time to one half or two thirds, and that’s enough.
1/3 to 2/3 is favorable for observation; it is essential to record the oil level
Fill it up to the full level for the first time as required, and keep it above the red mark on the scale thereafter. Check the instructions and follow the guidelines provided in the device’s manual.