Water-binder ratio in rubber production
Thread Content
Regarding the water-to-polymer ratio, I am still not sure whether it refers to the ratio of water in the polymerization tank to the polymer particles in that tank, or the ratio of water in the feed material to the polymer solution in the feed material. I urge all of you to speak up and help me resolve my doubts!
Reply to 1# jiangshaohua: It’s the feed ratio. If it’s the water-to-binder ratio inside the tank, then it’s like cooking porridge, haha! Typically, the water-cement ratio ranges from 4 to 6
Agreed, our factory has also set it this way, that is, the ratio of feed water to glue solution
Is the water-binder ratio set that high in your company? We’re very low!
Thank you all for your replies. It has improved me!
Reply to 4# jiangshaohua: What kind of factory is yours? What is the water-cement ratio? To explain in detail, let me analyze it for you!
Reply to 6# liwei3547: Are you Li Wei from Qilu? Please reply.
This post was last edited and replied to by liwei3547 on 2010-10-17 at 11:06. Reply 7# jiangshaohua: No, I’m from Beijing. I went to Qilu a couple of years ago. I wonder how their facilities have been upgraded over these two years.