Problems encountered with C200
Thread Content
Dear sea friends, I would like to ask: in the Honeywell PKS200, there is a card called the I/O Link Extender – what is its purpose? Also, in the C200, there are two I/O Link Interface Modules – what is their function? ? Why are A and B type I/O link cables used between the card slots and them? , Thank you
Why isn’t anyone answering? I’ve spent days trying to figure it out, but I can’t find any information on it
This post was last edited by Hardmen on 2010-10-21 07:49. The I/O link extender is an expansion card; your PMIO card cage should have a remote one as well. The I/O link interface module is the interface between the controller and the PMIO card cage. As for the I/O link cables A and B, they refer to a controller with two wires, with each wire connected to a PMIO card.
It seems you don’t know much about the C200 system; if you’re not sure, keep asking – your explanations are a bit vague, but that’s basically what I mean.
Reply to 4# superengr: Hehe, thank you