What to do if the cinnamon stick wobbles during production
Thread Content
Sometimes, the Cinnamon rods that are being produced normally start to shake for certain reasons. Even after stabilizing the feed rate, these rods continue to shake. Does anyone have any good solutions? What causes this problem, and how can it be resolved? ?
The reason for the wobbling could be the effect of intake air or the fact that the silicon core wasn’t secured properly during installation. The gas flow rate is well controlled, and there are no issues with the precautions for installing the silicon core. It’s normal to see some swinging when it’s small
Swinging is normal; if the swinging intensifies, it is possible to appropriately reduce the feed rate, and then gradually increase it again