What is the typical pressure drop of the pre-pump filter?
Thread Content
What is the typical pressure drop of a pre-pump filter? Thank you
It can be considered at 10 KPA
The pressure drop of a filter is determined not only by the type of filter (basket type, Y-type, T-type) and its parameters (mesh size), but also by factors such as the flow rate of the material and its viscosity. Moreover, 10 KPa might be a bit high; I once calculated for a 200-meter long gasoline pipeline with four valves, 5 elbows, and 4 tees, where the flow rate was around 1.5 m/s, and the pipeline resistance was only 11 KPa – this information can serve as a reference for the original poster
Thank you so much! I finally found it