How to handle equipment flanges that are out of specification
Thread Content
The maximum nominal diameter of the equipment flange is 2000 mm; what should be done if this value is exceeded?
Refer to the specifications, set the dimensions yourself, and conduct calculations for verification.
For example, if my diameter is 2300 mm, should I design it based on the 2000 mm value?
jb 4732 – check this standard to see if it can be helpful
It’s not necessary to use JB4732; you can set an appropriate size by yourself, perform the calculations, and it will be fine as long as the checks pass. SW6 can also be used for the calculations