The impact of the specified initial flow rate for PRO/II products on the results
Thread Content
This post was last edited by longkui1990 on 2012-6-11 22:46. I would like to ask: what impact does specifying the initial flow rate of the product at the top or bottom of the tower during PRO/II tower simulation
Reply 1# 42317423 No impact
Reply to 2# kevin25: Then let me ask again – does that mean I can just choose any value as long as it’s within the range?
Reply to 3# 42317423: It cannot be arbitrary; it must stay within the specified range
It depends on the system you’re separating. Usually, a value is assigned arbitrarily at first, but it shouldn’t be higher than that of the feed material; after convergence, fine-tuning can be done to see how to get it as close as possible to the desired values, hehe
It should be close to the quantity you want to simulate, so as to achieve better convergence