【Daily Question】2011-1-26 Project Management: (Wednesday)
Thread Content
Fill-in-the-blank: The distance between two butted welds should not be less than （ ） times the thickness of the weldment. When heat treatment after welding is required, this distance should not be less than （ ） times the thickness of the weldment. Answering requirements: 1. Please hide your replies in this post; no scoring will be given unless they are hidden. Hidden method: http://bbs.hcbbs.com/viewthread.php?tid=492556&page=1#pid2695620 2. Each participant will receive a wealth reward of 1 to 3 points; those who provide insightful and in-depth responses will receive higher scores. 3. The top 50 participants will be awarded prizes, while those ranked after position 50 will not be scored. Once the new daily question is released, the old post is closed. 4. All the questions I created were formulated based on relevant standards and experience; if there are any disputes regarding the answer key, please post discussions separately. The answers can be found at: 3 6
The distance between the two butting welds should not be less than 3 times the thickness of the welded piece; when heat treatment after welding is required, this distance should not be less than 6 times the thickness of the welded piece
The distance between two butting welds should not be less than 3 times the thickness of the welded part; when post-weld heat treatment is required, this distance should not be less than 6 times the thickness of the welded part
Reply 1# onefly2009 3 6
Moderator, that’s too unfair. Everyone else gets five or six points, but you only give three? How can you be even more stingy than a woman?