Forging strength issues
Thread Content
This post was last edited by Si A Ge on 2011-2-12 at 17:33. Dear sea friends: The stainless steel impeller sleeves for reaction vessels can be manufactured using pipes, round bars, or by first forging them and then processing them. After calculating the costs, it turns out that manufacturing them directly from round bars is cheaper than the method of forging first and then processing. However, there is one issue I’m not quite sure about: Is the strength of the impeller sleeves produced by forging first and then processing higher than that of those made directly from round bars? Thank you first!
Reply to 1# Fourth Prince: The strength after forging is higher than that of the unforged version