HCBBS Forum (English)
Submit Chemical Projects / Find Solutions
Amplify Your Requirements on a Broader Chemical Platform *Engineering · Technology · Equipment · Solutions*
Submit Request

Is the top of the raw water tank bulging and damaged?

2011-02-16View Original

Thread Content

I ask all fellow sailors: I know of several facilities whose raw water tanks used for wastewater stripping have not experienced any problems since they were put into operation. There is a degassing tank before the raw water enters the facility, and the raw water tank itself also has a water seal. Then why can’t the large amount of gas present in the raw water flowing into the external equipment be removed promptly? Will damage of varying degrees always occur? As is well known, bulging of the tank top occurs when there is air in the external device; apart from requiring that the external device be stable, are there any other good solutions?
Reply #22011-02-16
The water seal tank isn’t very reliable to begin with – it gets clogged easily. One possible reason for this is poor degassing in the raw material degassing tank; it’s very likely that the clogging is caused by the water seal tank. If the top of the raw material water tank is unobstructed, then there shouldn’t be any major issues with degassing. By the way, where does the degassed raw material water go?
Reply #32011-02-17
Usually, the vapor from the raw water tank is sent to the flare. However, if the torch back pressure is high, it will affect the degassing effect. Furthermore, an increase in the temperature inside the tank also leads to an increase in the gas phase pressure within it. Therefore, the temperature of the raw water should be reduced as much as possible; secondly, the tank top should be insulated to prevent sunlight from hitting it and causing an increase in the vapor pressure inside the tank.
Reply #42011-02-18
The exhaust gas from Kyobo’s degassing tank is sent to the low-pressure gas or acidic vapor line!
Reply #52011-02-19
Reply to 2# iceknife: Deaerate the tank first, then vent it in the adsorption tank
Reply #62011-02-19
Reply to 5# qrcl Oh! :$ The degassing tank is depressurized and vented to the flare, while the water seal tank is followed by the adsorption tank for venting.
Reply #72011-07-09
Replace the degassing tank with a degassing tower and add an amine solution absorption process

Submit a Project

**Looking for Chemical Technology, Equipment & Solutions?** No Registration Required Broader Platform Exposure | Global Chemical Service Provider Connections

Submit Request — Free Consultation

Disclaimer

This is an automated machine translation of the original thread. Some technical terms may have inaccuracies; the original text shall prevail. Click "View Original" at the top right to access the source page, which supports IP-based automatic real-time language translation. Please watch out for contact details and sales inducements to prevent fraud. All content and translations are for reference only, representing solely the poster's personal views. For enquiries, email service@hcbbs.com.