Questions about VMGSIM
Thread Content
This post was last edited by Douzi1061 on 2011-3-2 09:08. I have just started using the VMGSIM software, and it seems to be quite useful for calculating material balances and developing plans in sulfur recovery processes. I would appreciate it if everyone could tell me where to enter the volume ratios and flow rates of various components after they have been entered in the components section, as well as how to set up the model. Can lbmol/h only be converted from mol/h, and not directly derived from mol/h? If possible, I would be extremely grateful if kind friends could teach me personally using an actual material balance sheet. QQ: 753006528.
I’m also learning this software...
I didn’t quite understand what the original poster meant. After each component has been entered in the components section, you go to the process interface, add a material stream there, and by double-clicking on that stream, you can enter the temperature, pressure, and flow rate. There are many different units for measuring traffic; simply enter any one of them, and the software will automatically convert it.
Don’t place too much trust in simulation software; it’s just a calculator – you need to understand how to perform the calculations yourself so that it can carry them out for you.