What is an appropriate loading factor for the polymerization reactor?
Thread Content
This post was last edited by wang*neng on 2011-3-8 at 16:11. Is the filling factor the same for polymerization reactors used in the production of various types of PVC? What are those values?
We have a 70-cubic-meter reactor for producing Type 5 resin, with a filling factor of 0.9
It depends on the actual process conditions; generally speaking, the resin type 3 has a lower value compared to type 5 – type 5 is around 0.9, while type 3 is around 0.86. Additionally, the operating conditions of the circulating water also need to be taken into account.
Agree with the above statement: a 70-cubic-meter reactor is used to produce Type 5 resin, with a filling factor of 0.9
Agree with the above statement: a 70-cubic-meter reactor is used to produce Type 5 resin, with a filling factor of 0.9
For a 70-cubic-meter reactor used to produce Type 5 resin, what is the maximum amount of monomer that can be added? What is the water-to-oil ratio?