How to modify Aspen’s convergence method
Thread Content
I’m performing a distillation simulation with circulating flow, and the results always show \"results available with errors\". How can I change the convergence method to avoid these errors? I’d appreciate guidance from those who are more experienced in this area! !
Convergence selection in the setup-configuration of the tower
The convergence method for circulating flow is not the one mentioned above; that is the convergence method for towers. For circulating flow, it should be selected directly under the ‘convergence-conv option-default method-tears’ setting. There are WEGSTEIN, Newton, Broyden, etc. But I guess the reason is usually not related to the convergence method; it must be some other factor
Reply to 3#: I’m also stubborn. Indeed, the result remained the same even after changing the convergence method. . .
Could you upload the source file for everyone to see? If it’s a confidential matter, then no need.
Reply to 5#: I’m also quite stubborn; since I’m just starting out, I’m sorry I can’t share it. I hope that once I’ve improved my skills to an Aspen level, I’ll be able to share them at that time. I hope my fellow sailors can give me more guidance on any further questions!
Post the error messages from the Control Panel so everyone can see them, should work, right?
Reply to 7# Liangxiao ERROR: The Convergence block $OLVER02 did not converge normally in the final pass