A question regarding coalbed methane purification
Thread Content
My operating pressure for coalbed methane is 0.3 Mpa; after being pressurized by the compressor, the gas enters a molecular sieve dryer for thorough dehydration. What pressure level is necessary to ensure the smooth progress of this process? I’m not sure how this pressure is determined – are there any relevant standards? I would appreciate guidance from those with experience in this field
Reply to 1# kanghui110: To increase the pressure of coalbed methane, it is necessary to remove oxygen in advance; otherwise, an explosion will occur when a certain pressure is reached. As for this limit, it depends on the amount of oxygen present