Plate thickness of urine storage tank
Thread Content
Dear everyone: The initial design for the urine tank specified a plate thickness of 8 MM, but this was changed to 10 MM in the final version. Plates with a thickness of 8 MM have already been purchased based on the initial design. At this point, it’s a bit late to change the materials without affecting the project schedule. Is it possible to use the 8 MM plates anyway? The storage tank has a capacity of 300 cubic meters; do anyone have any good construction methods or suggestions regarding whether these plates can be used?
After communicating with the design institute, it should be fine to add reinforcement bars externally or internally.
Have seen 350M3 urine tanks; the cylinder and bottom plate are 6MM thick, while the top cover is 5MM thick. The material used is 00CR19NI0
It can be used just fine; after all, the urine tank isn’t needed during normal production.
Reply: For 2# – the urine tank used in the carbon dioxide stripping process for urea production has dimensions of 8500*5*5930; it operates at atmospheric pressure. The weld coefficient might be 0.7, so you can use 0.85 instead. Secondly, follow the approach suggested by the friend from the second floor.
Sure, it’s totally possible. Our urine tank has dimensions of DN8200×8000×8, with a capacity of 422 m3
I am very grateful for everyone’s helpful responses. I have made the corrections as suggested by the person in floor 2, and production is currently in progress on site.
There should be no problem; it can be used. I once worked at a pressure vessel company for some time
Sure, our methanol storage tank is DN8000×9000×6 with a capacity of 400 m3; it was designed by the Fourth Research Institute.
It can be used; after all, the urine tray is at atmospheric pressure