How to verify the strength of tower structures supported by ear seats
Thread Content
For packed towers with a large diameter and long length, where support brackets are required due to process requirements, how should the wall thickness of the cylinder be checked? Thank you for your insights!
You’d better have the design institute help you calculate it; software is needed to determine the strength. Our equipment department can also do the calculations; send me the drawings by email and I’ll see if I can help you
The key issue is that software cannot compute this type; no method for calculation has been found.
Reply to 3# whsjy2002: Oh, I remember; that SW6 software can be used for calculations. Our equipment department seems to have worked with that manufacturer before as well.