Everyone, please help me! Pipeline flexibility calculation φ27X1
Thread Content
I have been working for only a short time, and recently I encountered a task that required performing flexible pipe calculations and designing N-shaped compensators. The longest straight pipe section in my system is 57 meters long, and it is made of stainless steel pipes with a diameter of φ27X1. Does the book mean that a piping system refers to combining all the pipes in a system and considering them as one? Should we pick out the longest one first and calculate it? Thank you all so much! I’m truly grateful!
We need to check the temperature and pressure; if the piping system is taken into account as well, a simplified calculation will not be accurate. Could we set some conditions for the piping equipment?
The temperature is room temperature, the pressure is 2.2 MPa. What do you mean by “can we set some conditions for the piping system”? ”Thank you.
If the piping system is considered together, how is it calculated? Thank you!
Personally, I think this pipe doesn’t need to be considered a small-diameter pipe; at normal temperatures, as long as there is some flexibility in the pipe due to bends, there should be no problem
Does anyone have any recommendations for books on the flexible calculation of pipelines? I’ve read some books, but I still don’t quite understand it. Thank you all; could you please recommend something for me? Thank you!
Is the calculation of pipeline flexibility complicated? I wonder if it can be done just by looking up a table?