Water ring vacuum compressor
Thread Content
For water-ring vacuum compressors, is there a requirement regarding the amount of water used? If so, what should be the position of the water within the pump chamber in order for the pump to operate at its optimal level?
Yes, I am learning about *this area. It seems to be a problem where the liquid level reaches the shaft when the pump is not running.
Are you learning *? Is there any material on this topic? Can I learn together with you?*
Reply to 3# Yongle99: Leave your email address, or contact me at hebliud@gmail.com
laobai2008@163.com Thank you
490537514@qq.com I want to learn* it too
The water level should be the same as that in the water vapor separation tank; it is automatically controlled by a control valve, with additional water being added automatically when the level drops.
Ceramic water ring vacuum pump? The make-up water is directly added to the pump chamber and then discharged to the water vapor separator; from this process, no specific requirement is placed on the liquid level.
There are requirements for water; it must be above the shaft (probably up to this level). Because if there is too little working fluid, it’s impossible to form a liquid ring, as one would expect. It doesn’t matter if there’s more; after all, the impeller is eccentric, so in any case a moon-shaped space of a fixed size will be formed.
Yes, you can check the manufacturer’s instructions – they specify the amount of working fluid required as well as the pressure of the working fluid. The instructions provided by Nasim Siemens Vacuum Compression Equipment Company are the most comprehensive.
512258906@qq.com Thank you, I’d like to learn* it too