How to trim a 90° elbow into a 60° elbow? I earnestly ask the experts for their advice!
Thread Content
I encountered a 60° elbow in the piping layout diagram, and it was impossible to create it properly in the 3D model. Can a 90° elbow be modified to have other angles?
Stop posting questions everywhere; you’ve already posted this thread. If someone is able or willing to, they will surely answer you. There’s no point in posting everywhere – do you want to end up as an advertisement on a street pole?
Reply to 2# aicr317: Okay
Reply to 1# pdms_pipe: There are 2 methods. 1. If the 90-degree elbow you mentioned is one with an adjustable angle, then simply change its attribute angle to 60 degrees; if it’s not an adjustable-angle elbow, then create a new one. 2. Directly create a 60-degree elbow, and it can be used immediately. Both of the above methods involve database creation.
Reply to 4# applefatten :) Thank you!
In the command line, enter angle 60
Hit it with a hammer, then click replace
Reply 7# S20060607 ?
Reply to 8# zhouph on floor 7: Could you be more specific? Thanks
I think the user who asked the question was using PDMS, while someone else replied that it was PDS. The question was poorly phrased, and the answer wasn’t good either.
Reply 6# ioribym is correct