Corrosion protection for ammonia storage tanks
Thread Content
Could that expert give some advice? For the anti-corrosion treatment of the ammonia storage tank, epoxy resin paint is used, in six layers. What will be the effect?
More layers are not necessarily better, as their expansion coefficients differ, which can lead to peeling and delamination; the right number of layers is what matters
Six layers will do. . . . Appropriate
Epoxy coal tar pitch, 200um is sufficient
The project has been completed. The specific process is as follows: sandblasting for rust removal, followed by acetone cleaning. Epoxy resin and T31 curing agent are used; after mixing them together, six coats are applied. The effect is quite good. Thank you all for your concern and support.
Could you tell me what the thickness of the epoxy coating is? There was a project recently where the supervisor required this figure