Seeking guidance on the design process for liquid sulfur storage tanks
Thread Content
I’m just starting to work with this, so thanks to everyone for any advice you can offer； A 500M3 liquid sulfur storage tank is to be installed at the factory, but how should the top of this tank be sealed? Are there any other aspects to consider in tank design? Thank you! ! ! The process is as follows: Liquid sulfur, after being sealed with sulfur, goes to the ——> liquid sulfur tank ——> pump ——> liquid sulfur storage tank
There is usually an air vent on the top of the tank. I’m not sure what you mean by sealed Is the purpose of setting up the sulfur tanks to load liquid sulfur? In such cases, the tank foundation is usually designed to be relatively high to provide sufficient space for loading liquid sulfur.
Leave a sufficiently large vent pipe on the top of the tank; it is preferable to use a jacketed vent pipe