I need specific instructions on the calibration and troubleshooting of Maggarda level gauges, thank you!
Thread Content
Calibration method for Magradar level gauges? Faults: 1. Fluctuations 2. Liquid level too low or too high 3. No change in liquid level at a certain point 4. Inconsistent output signals, and so on... I hope experts can explain in detail how to deal with these faults as well as what other faults may occur. I am extremely grateful!
The instructions provide relevant information; for common issues, performing the basic factory calibration of the instrument once usually resolves them
The original poster’s statement is too general. In my opinion, there are usually no major problems with the gauge; what matters is the operating conditions. Only by describing those conditions in detail can the cause be analyzed. Installation and interference can both cause the aforementioned problems. Operating conditions are very important
I have seen three models of Magg: 1) 705 guided-wave radar, 2) 601 interface level gauge, 3) 601 radar level gauge. To briefly explain the 601 model: a 4 mA set point corresponds to the lower limit of the measurement range, while 20 mA represents the full scale; you simply enter the desired height value there. The tank height is entered as the height of the equipment
Reply to 4# mu*ang1988: Why don’t you make your own assumption and explain it?
I’ve never heard of this brand. . . . Where is it?