Aspen’s simulation of the mixing of two fluids never yields any results
Thread Content
For the first practice exercise, the task was quite simple: mix 1000 m3/hr of low-concentration alcohol (30% w/w ethanol, 70% w/w water, 30°C, 1 bar) with 700 m3/hr of high-concentration alcohol (95% w/w ethanol, 5% w/w water, 20°C, 1.5 bar). Find the temperature and volumetric flow rate after mixing. I tried various modules of Mixer, and the following message was displayed: Please advise -> Processing input specifications ... ****TERMINAL ERROR: An account-info paragraph must be provided ******************************************************************** * The error severity level is 0
Try using a heater to see if it works
Reply 1# lycenet: The ACCOUNT-INFO PARAGRAPH MUST BE PROVIDED. For versions below V7, you can enter any username.
Reply to 3# rjb119: Okay, I’ll give it another try
Reply to 2# z717980104: No module will work; I just found out that for versions prior to V7, it’s necessary to enter any letters in the accounting field
The ACCOUNT-INFO PARAGRAPH MUST BE SUPPLIED – that’s the reason mentioned above