We are about to install dozens of new electric actuators soon. What should be taken into consideration during the commissioning process? Please come in
Thread Content
:) Beginner: The factory has recently expanded, and a new project is about to enter the installation and testing phase. I’m fortunate enough to be involved in this project, and I was wondering if there are any things I should pay attention to, or anything particularly important to keep in mind? :lol
They are supplied as complete sets; pay attention to the flow direction of the valves and avoid installing them in the wrong direction. For the actuator, make sure the wires are connected correctly; it’s difficult to fix things if they’re connected wrong. . .
Did you buy a complete set of valves, or did you purchase the actuator separately and then install the valves yourself?
Reply to 3# shlapar: The valve body and the actuator are from two different manufacturers.
Reply 4# **Instrument technicians: Do you purchase the valve body and actuator separately and then assemble them by yourselves?
It depends on the technical requirements; during assembly, just paying attention to the connection quality of the shafts is generally sufficient