Water separation issue in slurry tank
Thread Content
In our catalytic slurry tank, over time, a lot of water accumulates on the surface of the slurry inside the tank, and it’s very difficult to remove this water. Please ask experienced friends from Haichuan to share some solutions. Thank you!
Reply to 1# Loyalty: We have manufactured oil-sand separation tanks that are capable of effectively separating sand and water; at the same time, they also enable the recovery of oil and gas. The system we develop consists of seven or eight pieces of equipment.
Heat it up; add a mixer to the oil tank. Dehydration must be carried out frequently – there is no better way
There is a partition inside the tank; when the water level rises, it will overflow over the partition~~~~ Start the pump!
We are also troubled by this issue: the density of the oil slurry is higher than that of water, and the temperature is high. We are concerned that poor temperature control could lead to boiling of the water inside the tank, while the presence of water outside the tank affects the accuracy of measurement. So we really don’t know what to do in this regard; we hope someone with more experience can offer some advice.