Adjustment of the current-exerting press for electrolyzer elevation
Thread Content
This post was last edited by sunjl1981 on 2013-1-6 21:37. When increasing the current in the Kyocera electrolyzer, should the nut regulating the oil pressure be loosened by 2–3 MM? When reducing the current, by how much does the current need to be reduced in order to adjust the oil pressure to 9 MP? Is the oil pressure adjusted according to changes in the tank temperature? # + + . hcbbs
This post was last edited by jhzxw on 2011-12-25 23:22. The essence of hydraulic pressure adjustment is to make adjustments in response to changes in temperature and pressure.
The last edit to this post was made by tclvjian on 2011-12-26 at 13:56. During the current increase process, the nut must be loosened; it can only be tightened after the temperature has stabilized and 2 hours have passed. When the gas phase pressure in the anode chamber is 5 KPa, 15 KPa, 25 KPa, and 35 KPa respectively, the oil pressure corresponds to 6.5 MPa, 7.0 MPa, 7.5 MPa, and 8.0 MPa respectively
This post was last edited by tclvjian on 2011-12-28 16:02. Thank you! Does the current rise from 12KA to 14KA to loosen the nut? Does not loosening have a big impact? When parking normally, there is no need to increase the oil pressure; but does increasing the oil pressure to 9 MPa are required in order to reduce the current from 14 KA to 10 KA?
We are low-density electrolytic cells; we can’t speak carelessly! Hehehe!