What kind of pump is suitable for high viscosity?
Thread Content
I plan to make construction adhesive; what kind of pump would be suitable? Thank you!
For materials with high viscosity, screw pumps or plunger pumps can be used; these low-speed pumps are capable of handling very viscous substances.
It is recommended to use a screw pump, as it facilitates maintenance
A gear pump can be used; if a higher pressure is required, a screw pump can be employed
Use a screw pump. We used gear pumps before, but the results were not good; screw pumps are better.
Gear pumps are sufficient for low flow rates, while screw pumps are used for high flow rates
It is recommended to use a screw pump; a gear pump is also an option.
Reply to 6# tjlgsy: Thank you!
Reply to 7# lhjj: Thank you for the reply!
How about gear pumps? However, the operating cost of gear pumps is relatively high.
We have never used screw pumps, so we’re not sure whether these pumps can transport slurry; gear pumps are not reliable