How to draw angle pipes in PDSoft
Thread Content
How to draw angle pipes in PDSoft? Assume that it is only known that the nozzle makes an angle of 30° with the XY plane, its elevation is 1000, and piping is laid at an angle relative to the nozzle up to an elevation of 2200.
Personal opinion: Set the nozzle height on the device to 1000, tilting it upward by 30 degrees (first move and rotate the coordinate axes); next, draw the pipeline with a length of 2200 first (making sure the horizontal distance from it to the nozzle is more than 5m), then start routing the pipes from the nozzle, enable the extension mode, and connect it to the high-pressure pipeline at 2200.
Reply to 2#: Actually, I don’t want to leave. Thanks for your advice; I’ve tried it and it works