Seeking help with the Automated placement command in PDS
Thread Content
In the piping, I first used the Place command to draw a pipe segment and a 90-degree elbow. Due to the angle of connection, I then used the Skewed intersection feature in the Sketch command to connect them. Finally, I used the Automated placement command to carry out automatic piping. However, I had a question: since I didn’t delete the existing pipe segments before performing automatic piping, would the pipes generated automatically overlap with those existing segments? After I connected them with Sketch lines, the newly drawn Segment lines and the existing ones do form a complete center line. I’m seeking help from experts; thank you! ! !
If there are no Type C or Type P errors, then there is no overlap
It seems the original poster is referring to two pipe sections; in other words, there are extra welds, but it doesn’t pose any problem. If you want a single pipe, just delete the pipe segment and then lay the pipe again