What is the density of acidic gas in a wastewater stripping unit?
Thread Content
Our unit has not had its acidic gas density measured since it started operation; could any expert tell me why? Thank you
The density of acidic gas in our device is 1.4
Acidic gas is a mixed gas, and its density can be determined either by direct measurement or through indirect measurement followed by calculation. 1. For direct measurement, a gas densitometer can be used, or the density measurement signal from a mass flow meter can be employed ； 2. Determine its composition and calculate the density using gas formulas. However, such calculations will have certain deviations, requiring corrections for some parameters or components as non-ideal gases.
How is the hydrogen sulfide content in acidic gases and acidic water calculated? Is it calculated under standard conditions?
Analyze the components and calculate based on molecular weight; it’s around 1.3 to 1.5
Is this the same as the acidic gas produced from solvent regeneration? Is the density the same?