Issues regarding cylinder manufacturing and heat treatment
Thread Content
I currently have a cylinder with a diameter of 600 mm and a length of 600 mm. The material used is a composite sheet of N06600+Q345R, with a thickness of 3+25 mm. Do those who have experience in manufacturing know whether it’s possible to roll such a cylinder? Could there be any problems with the composite sheet during the rolling process? Will heat treatment after the cylinder is manufactured have an adverse effect on the cladding? Thank you
It is a nickel-based alloy composite plate that can be cold-formed； Given the relatively high deformation rate, medium-temperature forming (550°C–600°C) can also be employed. Stress-relief heat treatment is required after shaping, with no adverse effect on the material properties.