Regarding the pipeline slope issue
Thread Content
In PDMS, if slope is applied to branch A of a pipeline that has already been created, will branch B, which is connected to it via a tee, automatically have a slope applied as well? Is a elbow with a radius of zero automatically added at the tee of Branch B? Everyone is welcome to discuss it.
It is necessary to set the slope again for branch B through slope adjustment; branch B can achieve a slope without the need for elbows.
When performing the slope adjustment, the tee does not shift at its original center of gravity; instead, its overall position coordinates decrease. As a result, after the slope adjustment, the tee is no longer aligned with the starting point of branch B, and thus a dashed line appears. Generally, a bevel is added at the solder joint and the next component to form a straight pipe section.