Gasifier burner interlock
Thread Content
Help: Interlock conditions for the burner in a gasification furnace
Choose two out of three: pressure below 1.2, temperature above 60 degrees, flow rate below 10 cubic meters.
1. Low low flow rate at the burner cooling water inlet (three out of two). 2. High high temperature at the burner cooling water outlet (three out of two). 3. High high difference in flow rates between the burner cooling water inlet and outlet (three out of two). The specific values vary; the technical supplier should provide them to you.
Thank you, this is very helpful to me::), thanks for sharing; please keep helping in the future
Let me check as well to see what the popularity is. But for the burner cooling water parameters, it seems we have five of them: flow rate LL, flow rate difference HH, outlet temperature HH, pressure LL… What else was it? I’ve forgotten
Burner cooling water interlock conditions: (4 out of 2) Low low inlet flow, High high outlet flow, High high inlet pressure, High high outlet temperature, 100
It’s listed on the PID or on the interlock diagram! This still needs to be discussed.
Only the standby pump is started, and there are high flow rate differences, low inlet flow rate, high inlet pressure, and high outlet temperature. That’s pretty much it! ! !
Only the standby pump is started, and there are high flow rate differences, low inlet flow rate, high inlet pressure, and high outlet temperature. And also (under the conditions of high level of coolant water in the emergency burner and a fault in the burner’s coolant system, the coolant water for the emergency burner can be maintained for a while) – that’s basically all there is! ! !