HCBBS Forum (日本語)
Submit Chemical Projects / Find Solutions
Amplify Your Requirements on a Broader Chemical Platform *Engineering · Technology · Equipment · Solutions*
Submit Request

Q345R材の板厚予熱問題

2020-07-20View Original

Thread Content

なぜQ345R材の溶接部の厚さが25mmの場合は予熱温度を80℃以上にするのに、24mmの場合は15℃でよいのでしょうか?
Reply #22020-07-28
予熱により溶接後の冷却速度が遅くなり、溶接応力が低減され、ひび割れの発生が防がれます。予熱温度は、鋼材や溶接棒の化学組成だけでなく、溶接構造の剛性や溶接方法、環境温度などにも関係しています。 NB/T47015-2011 4.4予熱 表4ではFe-Iクラスについて規定があり、規定された引張強度の下限値が490MPa以上で、かつ継手の厚さが25mm以上の場合、最低予熱温度は80℃とする℃;それ以外の材料は、最低予熱温度が15℃です。 役に立つかわからないけど。

Submit a Project

**Looking for Chemical Technology, Equipment & Solutions?** No Registration Required Broader Platform Exposure | Global Chemical Service Provider Connections

Submit Request — Free Consultation

Disclaimer

This is an automated machine translation of the original thread. Some technical terms may have inaccuracies; the original text shall prevail. Click "View Original" at the top right to access the source page, which supports IP-based automatic real-time language translation. Please watch out for contact details and sales inducements to prevent fraud. All content and translations are for reference only, representing solely the poster's personal views. For enquiries, email service@hcbbs.com.