HCBBS Forum (日本語)
Submit Chemical Projects / Find Solutions
Amplify Your Requirements on a Broader Chemical Platform *Engineering · Technology · Equipment · Solutions*
Submit Request

SW6の計算時に管板で問題が発生し、計算書では筒体の大端の厚さを増厚するよう要求されている

2018-04-21View Original

Thread Content

sw6の計算時に「管板とシェル円筒の接続構造を変更する必要があり、シェル円筒の端部(フランジの太い部分)の厚さは12.43mmでなければならず、厚肉化部分の長さは92mm」という表示が出ます。これは管板が腐食した後の計算結果で、腐食前の計算では適切な厚さは12mmでした。これはどういう状況でしょうか?厚さを変えずに、どのように計算すれば合格できるのか?海友の皆さん、解決策を教えてください!
Reply #22018-04-26
計算ファイルをアップロードしてもらえますか?これはどの部品の計算時に出たもので、管板ですか?今のところ、このような状況には遭遇したことがありません。

Submit a Project

**Looking for Chemical Technology, Equipment & Solutions?** No Registration Required Broader Platform Exposure | Global Chemical Service Provider Connections

Submit Request — Free Consultation

Disclaimer

This is an automated machine translation of the original thread. Some technical terms may have inaccuracies; the original text shall prevail. Click "View Original" at the top right to access the source page, which supports IP-based automatic real-time language translation. Please watch out for contact details and sales inducements to prevent fraud. All content and translations are for reference only, representing solely the poster's personal views. For enquiries, email service@hcbbs.com.