HCBBS Forum (日本語)
Submit Chemical Projects / Find Solutions
Amplify Your Requirements on a Broader Chemical Platform *Engineering · Technology · Equipment · Solutions*
Submit Request

管継手の公称圧力の選定

2020-07-11View Original

Thread Content

管継手の公称圧力は、配管の設計圧力よりも1ランク高くすべきでしょうか?どの基準で定められているの?
Reply #22020-07-11
基準なんて必要ないよ!低すぎると使えないの?
Reply #32020-07-12
設計圧力に等級というものはなく、公称圧力で設計圧力を包含すればよい
Reply #42020-07-13
設計圧力が1.4Mpaの場合は、間違いなく1.6Mpaのバルブを選ぶべきです。設計圧力が1.6の場合、一般的には2.5を選びます
Reply #52020-07-14
根拠となる基準が何か、よく気づきませんでした。一般的には安全性を考慮してのことですが、もちろん2.0Mpaまで設計する必要はなく、25キログラムのバルブを選ばずとも、わざわざ40キログラムのものを使う必要もありません。

Submit a Project

**Looking for Chemical Technology, Equipment & Solutions?** No Registration Required Broader Platform Exposure | Global Chemical Service Provider Connections

Submit Request — Free Consultation

Disclaimer

This is an automated machine translation of the original thread. Some technical terms may have inaccuracies; the original text shall prevail. Click "View Original" at the top right to access the source page, which supports IP-based automatic real-time language translation. Please watch out for contact details and sales inducements to prevent fraud. All content and translations are for reference only, representing solely the poster's personal views. For enquiries, email service@hcbbs.com.