HCBBS Forum (日本語)
Submit Chemical Projects / Find Solutions
Amplify Your Requirements on a Broader Chemical Platform *Engineering · Technology · Equipment · Solutions*
Submit Request

熱電対

2018-04-04View Original

Thread Content

K型熱電対のマルチメーターで測定すると0.5mVでしたが、DCSでは実際に43度と表示され、DCSの設定では温度補正が見当たりませんでした。この補償温度が一体どこで補償されているのか、ご存知の方はいますか。この熱電対は温度変化に応じて動作し、信号タイプはFFです
Reply #22018-04-12
温度変化には補償が伴い、そうでなければ4-20mAの電流を出力することはできない。
Reply #32018-04-12
自分の温度センサーに補償抵抗や熱電対が内蔵されているか確認してください。もし内蔵されていなければ、外部から接続するか、固定値を設定する必要があります。
Reply #42018-04-12
0.5mVで約15°、補正温度を30度以上にするのが適切だ

Submit a Project

**Looking for Chemical Technology, Equipment & Solutions?** No Registration Required Broader Platform Exposure | Global Chemical Service Provider Connections

Submit Request — Free Consultation

Disclaimer

This is an automated machine translation of the original thread. Some technical terms may have inaccuracies; the original text shall prevail. Click "View Original" at the top right to access the source page, which supports IP-based automatic real-time language translation. Please watch out for contact details and sales inducements to prevent fraud. All content and translations are for reference only, representing solely the poster's personal views. For enquiries, email service@hcbbs.com.