HCBBS Forum (日本語)
Submit Chemical Projects / Find Solutions
Amplify Your Requirements on a Broader Chemical Platform *Engineering · Technology · Equipment · Solutions*
Submit Request

トーチシステムの設計規定に関する問題

2016-08-01View Original

Thread Content

トーチの内管(燃焼排ガスが流れる管)の直径について、トーチの分液タンクからトーチの放散主管までの直径以上でなければならないという規定は、どの規格に基づくものですか? 関連する規格の要求がなければ、この理論に従わないトーチシステムの設計例は存在するのでしょうか? 皆様、ご指導をお願いします。
Reply #22016-12-22
海外のトーチメーカーと交流したことがあるが、外国人は排出抵抗の低下が要件を満たせばよく、上記の規定を守る必要はないと考えている。それに、その点はちょうど逆に言ってしまっています。正しくは、トーチエリア内の主管のサイズは、エリア外の主管のサイズよりも小さくてはならないのです。

Submit a Project

**Looking for Chemical Technology, Equipment & Solutions?** No Registration Required Broader Platform Exposure | Global Chemical Service Provider Connections

Submit Request — Free Consultation

Disclaimer

This is an automated machine translation of the original thread. Some technical terms may have inaccuracies; the original text shall prevail. Click "View Original" at the top right to access the source page, which supports IP-based automatic real-time language translation. Please watch out for contact details and sales inducements to prevent fraud. All content and translations are for reference only, representing solely the poster's personal views. For enquiries, email service@hcbbs.com.