HCBBS Forum (日本語)
Submit Chemical Projects / Find Solutions
Amplify Your Requirements on a Broader Chemical Platform *Engineering · Technology · Equipment · Solutions*
Submit Request

計器インターフェースの公称直径

2019-05-23View Original

Thread Content

工業用金属配管設計規格において、設計圧力が6.3MPa以下、または設計温度が425℃以下の蒸気配管については、計装用接続口の公称直径は15mm以上でなければならない;上記の条件を満たし、かつ振動がある配管においては、計装インターフェースの公称直径は20mm未満であってはならない;主管の公称直径が20mm未満の場合、計器の接続口は主管の直径より小くてはならない。 上の計器インターフェースの公称直径は、どのように決定されたのでしょうか。
Reply #22019-06-13
工程で残される圧力取り出し用の短いチューブの規格のことですか?一般的にはDN15です

Submit a Project

**Looking for Chemical Technology, Equipment & Solutions?** No Registration Required Broader Platform Exposure | Global Chemical Service Provider Connections

Submit Request — Free Consultation

Disclaimer

This is an automated machine translation of the original thread. Some technical terms may have inaccuracies; the original text shall prevail. Click "View Original" at the top right to access the source page, which supports IP-based automatic real-time language translation. Please watch out for contact details and sales inducements to prevent fraud. All content and translations are for reference only, representing solely the poster's personal views. For enquiries, email service@hcbbs.com.