Pressing the material in the reactor using compressed air (water-based)
Thread Content
Compressed air is used to press the material in the reactor (for aqueous solutions), at a pressure of 0.2 MPa. Is it necessary to install a safety valve on the reactor? Can the discharge from the safety valve be directed into the vehicle’s exhaust system?
Check for toxic gases; normally, the exhaust gas from the safety valve should be in the absorption tower.
Safety valves are generally installed on reaction vessels. Our safety valve discharge pipeline is combined with the exhaust gas discharge pipeline, and a dedicated pipeline is used to send the gases to the exhaust gas treatment system
What pressure rating is the kettle designed for? If it is much greater than 0.2 MPa, then even with a safety valve in place, it will not activate~~~
There are two types of safety valve installations: one is for the safety of the container, and the other is for the safety of the process parameters. This is simply because the reactor can handle high pressures; it’s not necessarily the case that the safety valve must have the same pressure rating as the reactor. Its rating can be determined based on the process conditions.
If the design pressure of the boiler is greater than the maximum pressure of the wind (at the outlet of the wind compressor), it is not necessary to install a safety valve; otherwise, one must be installed