What type of valve is suitable for use with particles ranging from 0.1 to 0.5 mm flowing in pipes, to prevent clogging?
Thread Content
What type of valve is less likely to get clogged when particles ranging from 0.1 to 0.5 mm are flowing through the pipeline? It will still be used for a long time ； As shown in the figure
This type of clamp valve is the best – it’s wear-resistant and not prone to clogging; there’s nothing inside its flow channel 412372706
It is to be installed on 6mm stainless steel pipes; for pipes with a smaller diameter, how about using a hard-sealed ball valve?
With such a small tube, you can only use a needle valve
The needle valve has been tried; it gets clogged easily :(
Is the caliber that small? What are the temperature and pressure?
That is, it is recommended to add a nitrogen line before the valve – it can be used for intermittent purging to prevent blockages.
18782173397, I’ll try to come up with a plan