Is it necessary to measure the amount of fresh water used in catalytic cracking units?
Thread Content
Is it necessary to measure the amount of fresh water used in catalytic cracking units?
In energy management, failing to measure things leads to chaotic accounting.
Of course it needs to be remembered; water, electricity, wind, and steam are all important
Otherwise, how can energy consumption be calculated? Measurement is required
Measurement is required, but many companies’ water meters are not very accurate these days. Before the introduction of flue gas desulfurization, the amount used was very small; after that measure was implemented, it became necessary to carry out measurements
It still depends on your consumption level; if the annual consumption is less than 50 tons, having a flow meter isn’t very useful. If you can handle 50 tons per hour and don’t use a flow meter, then your energy consumption will be low, and so will your costs
Of course, it needs to be measured. This item is included in the material balance; although we don’t need several tons either.