What is the typical density of catalytic dry gas?
Thread Content
What is the typical density of catalytic dry gas? Does your facility calculate the volume or mass of the dry gas? If it’s volume, what density should be used?
Are everyone using mass flow meters?
The readings on our instruments are usually in cubic meters; a conversion is needed when performing calculations. The density is generally taken as 0.76 g/m3, and this value is calculated
Density can be calculated based on a full analysis of the dry gas; densities vary depending on the quality of the dry gas – higher densities are observed when there is a large amount of carbonaceous hydrocarbons or when the degassing effect of the regenerant is poor.
Could you provide the table or method for the calculation?
Multiply the metric square by (0.75-0.8)/1000 to get the tons