Thread Content
Float flowmeters are among the most commonly sold types of flowmeter products today; glass rotor flowmeters, plastic tube float flowmeters, and metal tube float flowmeters all fall into the category of float flowmeters. Take glass rotors for example; due to their easy installation, simplicity of use, and low cost, they account for the largest share of sales. All flowmeters have a measurement accuracy, which is what is commonly referred to as the range of measurement error. The following outlines some reasons that cause increased measurement errors in float flowmeters. The installation does not meet the requirements. Generally, glass rotameter are installed vertically; during installation, the tilt angle of the flowmeter must not exceed 20 degrees. Of course, some rotameter flow meters are installed horizontally. For horizontally installed rotameter flow meters, it is necessary to keep them level, with an inclination angle of no more than 20 degrees. There must be no ferromagnetic objects within 100 mm around the float flow meter. The installation location should be far away from valve diameter changes, pump outlets, and bends in the process pipelines; a straight pipe section of 250 mm length, equal to five times the pipe diameter, must be maintained ahead of it. Gas media are greatly affected by temperature and pressure. Flowmeters are calibrated before leaving the factory, with their flow scales set according to the temperature and density of the medium used by the user. Gas media are highly affected by temperature and pressure; therefore, it is necessary for the user to provide accurate values for these parameters. The density of liquid media changes significantly. Before calibration, the medium is converted to a density specified by the user, so that it can be calibrated using the flow rate of water under standard calibration conditions; therefore, if the density of the medium changes significantly, it can cause large errors in the measurements. The solution is to substitute the changed medium density into the formula to calculate the error correction coefficient, and then multiply the flow rate measured by the flow meter by this coefficient to obtain the actual flow rate. For metal tube float flowmeters, long-term use and pipeline vibration can have a certain impact. Various factors cause the moving parts of the float flow meter, such as the sensing magnet, pointer, counterweight, and rotating magnet, to become loose, resulting in significant errors. Solution: You can first verify by manually pushing the pointer. First, place the pointer at the RP position and check whether the output is 4 mA and whether the flow display shows 0%. Then verify sequentially along the scale. If any discrepancies are found, the position of the component can be adjusted. Overall, the float flow meter is a product that is easy to install and is widely used in various industrial applications, playing a crucial role especially in the measurement of small flow rates. In automated production, float flow meters can also meet modern requirements by enabling remote transmission and integration with control systems, thereby facilitating production processes.