Destination of gases from the solvent regeneration rich liquid flash tank
Thread Content
Where does the gas from the solvent regeneration rich liquid flash tank go – to the degassing tank or to the acid gas flare? If it goes to the degassing tank, is it treated before that?
It goes to the gas holder; the gas in the holder is then desulfurized before being used as fuel gas.
Have you analyzed the composition and sulfur content of the gas going to the degasifier?
Have you analyzed the composition and sulfur content of the gas going to the degasifier?
Is there a direct route to the acidic gas flare?
Of course it has been done; the sulfur content is definitely high.
Fortunately, the volume of gas in the solvent regeneration rich liquid flash tank is not very large.
Is it to recover light hydrocarbons and increase the benefits of the plant? Are you going to the crude gasoline tanks?
The acidic gas is sent to the flare and then recovered via the gas holder. I think that’s right; I’ll double-check later
Go to the degassing tank. The hydrogen sulfide level is very high; I did it once, it was around 10,000 ppm~