When is it appropriate to change from using steam generated by the slurry steam generator for heating to using water, and should this be done before or after injecting the raw material?
Thread Content
When is it appropriate to change from using steam generated by the slurry steam generator for heating to using water, and should this be done before or after injecting the raw material? Is it determined by temperature? Is it necessary to add water when the temperature of the general slurry steam generator reaches around 250°C?
The water supply needs to be improved before spraying fuel. According to before the node settler is rotated. There are no specific requirements regarding the temperature of the slurry steam generator; usually, steam protection is used, and there is also a certain amount of condensed water. It can be put into operation in accordance with the regulations for steam drums and boilers.