Switch to reciprocating compressor for reformed regeneration gas

You mean switching between two identical devices, right? Give it a try :) There are two compressors, A and B. Compressor A is currently in operation; it is planned to bring compressor B online while shutting down A for maintenance. The operation is carried out while maintaining constant flow pressure, and the specific method is as follows: First, start machine B and raise the pressure until it equals the system pressure, then maintain that pressure. Slightly open the circulation valve of unit A; while doing so, gradually increase the load on unit B until the load on unit A is reduced to its minimum value. Then close the discharge valve of unit A completely, ensuring that unit B continues to operate normally. It is possible to shut down Unit A by closing its suction valve, and then proceed with the shutdown procedures: cut off the oil, water, and power supply. Throughout the entire process, it must be carried out while keeping the pressure and flow rate of the pressure system constant. The check valve at the compressor outlet should be utilized fully, and at the same time, control should be provided via an exhaust valve in case this valve fails. The load reduction of Unit A refers to reducing the flow rate while maintaining pressure in the system; this is achieved by opening the circulation valve or the vent valve of the compressor itself in order to decrease the amount of fluid supplied to the system. Since it is unclear whether your loop valve system refers to a single device or some other configuration, it would be best to provide an illustrative diagram to facilitate discussion. For reference.