Loose point issue
Thread Content
Every time during maintenance, the tight spots get blocked, and it takes a lot of effort to clear them. I wonder if Haiyou has any good methods for loosening stuck parts, or ways to prevent blockages
The loose air in our equipment also gets blocked all the time; for those cases that are really difficult to fix, we just ignore them. When it’s blocked, there’s really no good solution; you can only use long pliers to pry it open.
Loose connections all use unpurified air, and water contained in this unpurified air is the cause of blockages, especially when the air humidity is high. Furthermore, it is not advisable to introduce loosening air too early, as doing so when the bed temperature is too low will cause the water to clump together upon contact with the catalyst. There are also many loose points in the design; generally, it’s not necessary to use them all – use them as appropriate.
It can be pried open using a rebar with a \"spiral\" drill bit.