Thread Content
The penetrant JFC-6 is used as a penetrant in detergents for metal surface treatment; it is the main surfactant material for removing oil stains from deep holes and cracks, and it also possesses certain emulsifying and cleaning properties. Isooctyl polyoxyethylene ether JFC is produced through the addition and condensation of isooctanol and ethylene oxide. Compared with traditional fatty alcohol polyoxyethylene ethers, isooctanol has a stronger ability to dissolve oil stains; it also exhibits higher penetration properties and better alkali resistance than fatty alcohols. Isooctanol maintains good fluidity at low temperatures – it does not solidify even at temperatures as low as -10°C – and its surfactant properties remain excellent in such low-temperature conditions. It also shows outstanding penetration performance in normal, moderate, and high temperature environments. This product is resistant to acids and alkalis as well as hard water; it has good water solubility. It retains its efficient penetration, wetting, emulsifying, dispersing, and cleaning properties even in highly alkaline environments. It is used as a penetrant in the textile printing and dyeing industry, and can be applied in sizing, desizing, scouring, and wool carbonization processes. It is also suitable as an additive for resin finishing. Used as a penetrant and degreaser in the leather industry. However, it is also necessary to pay attention to compatibility with other chemicals, and avoid mixing it with substances that may undergo chemical reactions or form precipitates, so as to prevent issues such as impaired performance or equipment blockage.