Leakage repair
Thread Content
Low-pressure steam is leaking from the bolt holes; how can this be addressed effectively without replacing the gaskets?
1. Check whether the bolts are tightened evenly; if not, make adjustments； 2. Glue injection at the snap.
Try tightening it first; if that doesn’t work, the only option is to seal the leak under pressure (by injecting glue)
Check if tightening is possible, then use a soft rivet plug
1. Tighten the bolts. 2. Glue injection for leak sealing. 3. Packaging box
If air leaks at the bolt where the gasket is located, it means the flange isn’t tightened properly; just loosen it again and tighten it properly!
Tighten it first and see if there’s still a leak
What the original poster is asking is: It’s already tight; nothing works, and it can’t be removed either. What should be done? Plugging leaks under pressure